The program works fine, but I need to make a bevel gear, and have no idea how to make the teeth. The main body is made by tapering a circle extrusion at 45 degrees. However, I cannot seem to get a sketch lined up either with the slope of the side of the extrusion* (the slashes as shown below), or at a 90 degree angle to this slope. Is there any way to align a sketch as I so desire, or another way to make a bevel gear?
*Drawing thereof:
_____
/_____\
*Drawing thereof:
_____
/_____\
Last edited by nukchebi0 (2008-05-21 23:15:08)