Pages: 1

 

2006-09-11 22:56:19
WackoPuppy
Member
+1|6974
Ok,No luck using search,so here goes

When I'm commanding,my map on the command screen constantly drifts up when I go to 2x or 3x zoom. Nothing I've tried so far will keep it stationary.

Please,can someone tell me what I am doing wrong or... not doing right?

Thanks in advance for any help
2006-09-11 23:55:19
GAIKIWARRIOR
Judge Death
+64|7207|PERTH WESTERN AUSTRALIA
Dont Press Wasd Buttons Or Cursors Just Mouse :d
2006-09-12 04:15:49
Twist
Too old to be doing this sh*t
+103|6987|Little blue planet, milky way
The screen wont "drift" unless your mouse is at the edge of it.... So just dont move your mouse... or at least keep it away from the edges.... At least that's what I HOPE you're asking, you''re not very clear about your specific problem.
2006-09-12 04:43:56
CrazeD
Member
+368|7137|Maine
This happens while in a vehicle too.
2006-09-12 05:31:49
BolvisOculus
Spagett!
+167|7083|Manitowoc, WI
Do you have a joystick plugged in?  I had a joystick that wasn't centered and it moved the comander screen.  Unplug your joystick or move it around to see if that's the problem.
2006-09-12 08:11:30
WackoPuppy
Member
+1|6974
Thanks for the replies!
It was my throttle. I have it programed for forward and backward movement. I increased the the center dead zone and the problem is now gone!

Thanks again for the Help !

Last edited by WackoPuppy (2006-09-12 08:12:02)

 

Pages: 1

Board footer

Privacy Policy - © 2025 Jeff Minard