Ok, I just installed this new DVD-ROM drive. When I try to put a CD in it it doesn't load. Same for my older drive that hasn't been touched. Could someone try and help me fix this problem?
is it installed correctly?
Yes. It is.ig wrote:
is it installed correctly?
I think it might be on master, but so is my other one. Could that be the problem?
Last edited by thareaper254 (2007-11-24 16:12:41)
that could be the prob just set one to slave or both to cable selectthareaper254 wrote:
Yes. It is.ig wrote:
is it installed correctly?
I think it might be on master, but so is my other one. Could that be the problem?
Yes use Cable select (CS) for the jumper and make sure you're using an 80 pin IDE cable and not a 40 pin.
What is cable select? Would it be better to set both to it?
Yes.
Alrighty, I fixed it. Thanks for the help. Have some karma