Does anyone know if this is expensive? i think Ive got the correct term, to get metal cut out from a sheet, the xbox 360 side panel! lol could anyone with any experience, case modding or other wise, say how expensive it is?
You aren't fabricating anything, just cutting out a design of some sort.
Look into water jet companies online, I'm pretty sure you could do something like that for under $50.
Look into water jet companies online, I'm pretty sure you could do something like that for under $50.
Well, it sounds like you don't have experience in the field.
If you want ornate metallurgy, you will need a welder. And skills.
But if you want a cheap way out, get some thin aluminum sheeting and a pair of tin shears and a dremel.
If you want ornate metallurgy, you will need a welder. And skills.
But if you want a cheap way out, get some thin aluminum sheeting and a pair of tin shears and a dremel.
Note the part about the 360 side panel, he doesn't want metal fabrication. Silly stryykerstryyker wrote:
Well, it sounds like you don't have experience in the field.
If you want ornate metallurgy, you will need a welder. And skills.
But if you want a cheap way out, get some thin aluminum sheeting and a pair of tin shears and a dremel.
Ha, metal fab. We had this at school.
One kid thought he'd be smart and do that hand-through-a-candle-flame trick with the Oxy welder, on full, on blue flame.
Needless to say, he was hospitalised.
One kid thought he'd be smart and do that hand-through-a-candle-flame trick with the Oxy welder, on full, on blue flame.
Needless to say, he was hospitalised.
My state was founded by Batman. Your opinion is invalid.
laughing my fucking ass offCheez wrote:
Ha, metal fab. We had this at school.
One kid thought he'd be smart and do that hand-through-a-candle-flame trick with the Oxy welder, on full, on blue flame.
Needless to say, he was hospitalised.
I'll do one in cast aluminum for $2500.00
It would be made to your specs. 1/4" thick and machined to a ready to install hardware state.
It would be made to your specs. 1/4" thick and machined to a ready to install hardware state.
You have the tools to professionally cut aluminum sheet without messing up the finish?ATG wrote:
I'll do one in cast aluminum for $2500.00
It would be made to your specs. 1/4" thick and machined to a ready to install hardware state.
Yes.
get creative.
yay for aluminium foil
Wow, the level of stupidity that an average human can achieve never ceases to amaze me.Cheez wrote:
Ha, metal fab. We had this at school.
One kid thought he'd be smart and do that hand-through-a-candle-flame trick with the Oxy welder, on full, on blue flame.
Needless to say, he was hospitalised.
LAMO HAHAHA I CANT STOP LAFING
lolz self pwnage didnt think it was possibleFlaming_Maniac wrote:
laughing my fucking ass offCheez wrote:
Ha, metal fab. We had this at school.
One kid thought he'd be smart and do that hand-through-a-candle-flame trick with the Oxy welder, on full, on blue flame.
Needless to say, he was hospitalised.