seb--morin
Im high
+152|7118|Montréal, Québec
OKay i got a x2 3800+ and i wanted to boost it a little... I oc'ed it to 2.3 ( 2.0>2.3) and its a very smooth increase since ppl raised this cpu to 2.8 and some even more... I didn't wanted to change to voltage or anything so i tried 2.3 as a 1st overclock. I raised the FSB to 230 x 10 (ht multiplier) . The system booted and the temperature a idle was just a little more than usual and load temp. was around 48-50.. I played about an hour of Cod4 and everything was all right and temperature stayed normal... Now tonight i came back from work and my pc didnt wanted to boot.. I got these 3 beep*beep*beep ... So i turn the pc of with the button.. I restart it and now it started normal but my oc is gone...  I dont know why.

help plz
Mr.Dude2
Member
+13|6802| Bay Area Calif. USA
A good site for your type of question is   http://www.guru3d.com/  . Check out the fourms. Hope it helps
SineNomine
Panzerblitz
+37|7201|SPARTA
what bios do you have?
seb--morin
Im high
+152|7118|Montréal, Québec
Poenix bios


thks for the link too, i looked over tom's hardware but i posted over here b4 creating an account on that site..
SineNomine
Panzerblitz
+37|7201|SPARTA
are these 3 beeps of the same length?
seb--morin
Im high
+152|7118|Montréal, Québec

SineNomine wrote:

are these 3 beeps of the same length?
hum i rly didn't pay attention.. Its the kind of beep that you normally have once when you boot but now its by burst of 3 and i continue as long as i dont turn off the pc

going to do some maintenance and eat a little i'll be back later .. thks for helping me

Last edited by 0seb--morin0 (2008-01-09 19:48:10)

Board footer

Privacy Policy - © 2025 Jeff Minard