Pages: 1

 

2008-02-14 16:00:09
mikeyc159
Member
+3|6532|Colorado, USA
The case i got came with a ton of screws am i going to have leftovers?

Also there are these little red washer type pads, are they used on the screws for the motherboard? which side of the motherboard do they go on? i can't find anything in the manuals.
2008-02-14 16:04:17
cospengle
Member
+140|6766|Armidale, NSW, Australia
What case is it?
2008-02-14 16:05:22
mikeyc159
Member
+3|6532|Colorado, USA
antec 900
2008-02-14 16:52:17
Slarty
Member
+37|6243|Ingerland
The case will (most likely) come with everything to cover all mobos, drives, cards etc etc so you'll probably end up with a few screws left over.
2008-02-14 16:56:19
mikeyc159
Member
+3|6532|Colorado, USA
what about the little red plastic washer? where do they go?
2008-02-14 17:16:53
Dragonclaw
Member
+186|6584|Florida

mikeyc159 wrote:

what about the little red plastic washer? where do they go?
RTFM tbh. Its all in there.
2008-02-14 17:18:05
Ryan
Member
+1,230|7122|Alberta, Canada

Men don't read instructions.
2008-02-14 17:30:59
jaymz9350
Member
+54|6856
If you have extra screws just keep them for later, my case had a ton of extra screws that have come in handy.  The red washers are for the motherboard but I have never used them.  They were needed on older computers to keep the motherboard from shorting out but new mobos don't have that problem, most use the mounting points to ground the motherboard.
2008-02-14 17:37:48
mikeyc159
Member
+3|6532|Colorado, USA
thanks for the help Jay +1 for you.
2008-02-14 20:04:15
aimless
Member
+166|6404|Texas
I got this fat grey washer with my cooler master case. What's it for? It's about 3cm in diameter and 1cm thick.

 

Pages: 1

Board footer

Privacy Policy - © 2025 Jeff Minard