After an intermittent period of time playing Far Cry 2, it will CTD, with no errors. I've tried patching, downloaded two patches, one which said my version was more up-to-date than the one I'm trying to install (which it isn't), and the other one said FC2 wasn't installed on my PC.
I've googled a good bit, but nobody seems to know a solid fix. I've tried DX9 instead of 10, lowered graphics to minimum, started a new story without quick saves, but to no avail.
I'm running Vista Ultimate x64. I do get an error saying "Recommended that you upgrade to Service Pack 1" when I start, but I'm unsure if I already am on SP1 or not, since my Vista isn't exactly legit. (Panz).
I don't think it's a driver issue, etc, because I've seen loads of posts on different forums with the same problem. Just wanted to know it the brains at BF2s could figure this out.
E5200 @ 3.6
HD 4670
4GB DDR2 @ 800Mhz
Gigabyte G31M-S2L.
If you need anything else just ask. Cheers.
I've googled a good bit, but nobody seems to know a solid fix. I've tried DX9 instead of 10, lowered graphics to minimum, started a new story without quick saves, but to no avail.
I'm running Vista Ultimate x64. I do get an error saying "Recommended that you upgrade to Service Pack 1" when I start, but I'm unsure if I already am on SP1 or not, since my Vista isn't exactly legit. (Panz).
I don't think it's a driver issue, etc, because I've seen loads of posts on different forums with the same problem. Just wanted to know it the brains at BF2s could figure this out.
E5200 @ 3.6
HD 4670
4GB DDR2 @ 800Mhz
Gigabyte G31M-S2L.
If you need anything else just ask. Cheers.
Last edited by Finray (2009-04-03 16:17:14)
