If you already read my other thread about SATA 3, you might know that I am trying to install Windows XP (I know its old) on to what was my secondary HDD. After the Windows initial setup was complete (The now vintage blue screen with yellow percentage bar) it says the HDD is damaged and setup cannot complete?
Now, I have never had any problem transferring/reading/writing when this served as my secondary drive, so wtf?
Is there a chance there is a problem with the other hardware? (It is all new stuff)
Should I run some kind of HDD diagnostic tool? Acronis?
Check for any old partitions that are causing an error?
I'm not sure what to do at this point. But I am hopeful with help
Now, I have never had any problem transferring/reading/writing when this served as my secondary drive, so wtf?
Is there a chance there is a problem with the other hardware? (It is all new stuff)
Should I run some kind of HDD diagnostic tool? Acronis?
Check for any old partitions that are causing an error?
I'm not sure what to do at this point. But I am hopeful with help