Pages: 1

 

2011-03-16 13:02:37
.Sup
be nice
+2,646|6710|The Twilight Zone
Hi guys I just received a LevelOne WAP-6011 access point and have an issue with it. I cannot login to its control panel. I've tried Chrome as well as Firefox and tried it with 3 different PCs. I was able to connect to it wirelessly with my Netbook, I was even able to chose to adopt settings from my old Linksys AP. Default ip to access its control panel is:192.168.0.1. When I type this into the browser's address bar it loads and after a while of trying to connect says cannot connect or if I'm offline it says cannot connect to internet. DHCP is enable and set to automatically obtain ip. The included CD only has a manual with no actual setup software. Any help is appreciated. thanks
https://www.shrani.si/f/3H/7h/45GTw71U/untitled-1.png
2011-03-16 13:13:31
bugz
Fission Mailed
+3,311|6569

Is there an ethernet port that you can physically plug in to just to do the config?
Steam: http://steamcommunity.com/id/ebug122
2011-03-16 13:18:47
.Sup
be nice
+2,646|6710|The Twilight Zone

ebug9 wrote:

Is there an ethernet port that you can physically plug in to just to do the config?
You mean to connect a PC and access point with a cat5 cable rather than wirelessly through router?
https://www.shrani.si/f/3H/7h/45GTw71U/untitled-1.png
2011-03-16 13:26:01
bugz
Fission Mailed
+3,311|6569

Yeah if you connect the PC directly to the WAP, you should be able to connect to 192.168.0.1 once you do the config, unplug and try connecting wirelessly.
Steam: http://steamcommunity.com/id/ebug122
2011-03-16 13:35:41
.Sup
be nice
+2,646|6710|The Twilight Zone
well I'm and sadly it did not work. I connected the access point straight into my PC using a CAT cable and it still could not connect. Strangely enough the command "ipconfig" also doesn't work.
https://www.shrani.si/f/3H/7h/45GTw71U/untitled-1.png
2011-03-16 14:02:00
.Sup
be nice
+2,646|6710|The Twilight Zone
okay I got it. I went into my router settings, under attached devices and found out that the default ip supplied in the manual and written on the access point was incorrect. I suspect its default ip is already in use by something else and something automatically assigned a different ip. thanks bugz
https://www.shrani.si/f/3H/7h/45GTw71U/untitled-1.png

 

Pages: 1

Board footer

Privacy Policy - © 2025 Jeff Minard