Does anyone know how to set deadzones on a Saitek Cyborg Evo?
I read the profile editor manual but didn't see anything in there.
Thanks
I read the profile editor manual but didn't see anything in there.
Thanks
why double post!?
It was an accident. I resubmitted because it told me to wait 60 seconds between posts the first time i clicked submit. Deleted
if theres nothing in the tabs in control panel/game controllers then youll have to use the SST software and program bands (i think)
Care to explain?Mad Ad wrote:
if theres nothing in the tabs in control panel/game controllers then youll have to use the SST software and program bands (i think)
Yes I see how to make bands but I have no idea how to set one zone to not do anything
Woo bobby.
No clue as how to help you, but whatever.
Yooo.
No clue as how to help you, but whatever.
Yooo.
Anyone helps me 1 karma a day for 3 weeks
thats 21 karmas! ok then, I take it you have the software. Open it up and right click the first axis to set and choose bands from the dropdown. (probably best to chose the forward and back axis first, axis y).
On the screen that follows, move the mouse about 3 marks above the red center line and click to set a band. Then do it again 3 marks below the red line to set the second band. Next, press the green tick up in the right corner to save these bands.
Now you can assign keypresses to the upper and lower band areas, for the y axis that would be W and S (forward and back) just dont assign anything to the middle area because thats your deadzone.
Save the profile (File:Save As and make a name for it) and then rinse and repeat for the x axis (keys A and D) and any other axis you have problems with.
hth
On the screen that follows, move the mouse about 3 marks above the red center line and click to set a band. Then do it again 3 marks below the red line to set the second band. Next, press the green tick up in the right corner to save these bands.
Now you can assign keypresses to the upper and lower band areas, for the y axis that would be W and S (forward and back) just dont assign anything to the middle area because thats your deadzone.
Save the profile (File:Save As and make a name for it) and then rinse and repeat for the x axis (keys A and D) and any other axis you have problems with.
hth