prototype
Member
+52|6789
I just installed a second hard drive into a Dell Dimension 2350

The drive I installed is a Maxtor diamondmax 16 80gb ata/133

I installed it using the ide cable that ran from the cd-rom to the mainboard instead of the ide cable from the first hard drive because there were not two ports avaiable on that one, (does that matter?)

I boot the system up and everything runs fine.

I go into control panel to add new hardware since the second HDD is not showing up on its own under MY COMPUTER.

I locate the second HDD in the list and when I click on it, it tells me the device it working properly.

My question, I should say my main question, is how to access the drive and begin using it.

Do I need to format it or do somthing else that I am missing? drive manager or somthing like that?

Thank you for any help you guys post
Bertster7
Confused Pothead
+1,101|7059|SE London

Right click My Computer, select Manage, pick Disk Management from the menu on the left -> set up your disk for use.
max
Vela Incident
+1,652|7045|NYC / Hamburg

right click "my computer" --> manage --> disk management --> click the drive --> format / create new partition

damn you

Last edited by max (2007-12-26 07:21:32)

once upon a midnight dreary, while i pron surfed, weak and weary, over many a strange and spurious site of ' hot  xxx galore'. While i clicked my fav'rite bookmark, suddenly there came a warning, and my heart was filled with mourning, mourning for my dear amour, " 'Tis not possible!", i muttered, " give me back my free hardcore!"..... quoth the server, 404.
prototype
Member
+52|6789
ok I did that but only one disk shows up in that list and I do not want to mess with my primary disk at all

do you think it is not showing up because I installed it using the ide cable that ran from the cd-rom drive?
prototype
Member
+52|6789
never mind I figured it out, thanx guys

Board footer

Privacy Policy - © 2025 Jeff Minard