Today, I rewired my computer because one cable from my modular antec tpq-850w was actually useless. I had in total 6 4 Pin molex connectors when only two were needed. One now goes to the power for my HDD and DVD-R/W driver and the other has all the four fans on it.
Right after going back to windows and open up my Nvidia monitor that comes with ntune, I get a new, out of nowhere reading "Temp4" and locked at 0 degrees Celsius.
I know its harmless but its not all. I tried everest and it gave bugged temperatures (mobo at 132 C!) Then the nvidia monitor indicated a wrong CPU fan speed.
I;
Reinstalled my drivers and resetted my bios settings.
The issues seem to be gone, readings are fine but the "temp4 0 C" is still here and it goes away when I open Xfire (It also kicks my GPU in 3D mode briefly the back to 2D.)
Here a few Screen shots
With Xfire turned on, was like that before rewiring and did not need xfire on.
Without Xfire
While it might be a tiny bug, I would like to be sure....
Right after going back to windows and open up my Nvidia monitor that comes with ntune, I get a new, out of nowhere reading "Temp4" and locked at 0 degrees Celsius.
I know its harmless but its not all. I tried everest and it gave bugged temperatures (mobo at 132 C!) Then the nvidia monitor indicated a wrong CPU fan speed.
I;
Reinstalled my drivers and resetted my bios settings.
The issues seem to be gone, readings are fine but the "temp4 0 C" is still here and it goes away when I open Xfire (It also kicks my GPU in 3D mode briefly the back to 2D.)
Here a few Screen shots
With Xfire turned on, was like that before rewiring and did not need xfire on.
Without Xfire
While it might be a tiny bug, I would like to be sure....